Search found 156 matches

by Lee
Thu Nov 01, 2018 10:52 pm
Forum: Forum Support
Topic: Server Upgraded
Replies: 0
Views: 41

Server Upgraded

Server software was upgraded from CentOS 6 to CentOS 7. This will allow easier implementation of PHP7 and beyond. You should already see a significant speed boost to the site.
by Lee
Thu Oct 25, 2018 9:07 pm
Forum: Firmware
Topic: Firmware upgrade issue
Replies: 3
Views: 164

Re: Firmware upgrade issue

Good to know, thanks!!
by Lee
Mon Oct 22, 2018 5:47 pm
Forum: Firmware
Topic: Firmware upgrade issue
Replies: 3
Views: 164

Re: Firmware upgrade issue

I have Win10x64 on my Surface. Honestly, I just let it auto-detect after installing Arduino IDE and it works great.

Have you tried to "Search for new hardware"?
by Lee
Thu Oct 18, 2018 6:25 pm
Forum: General
Topic: Flash for beginners
Replies: 4
Views: 272

Re: Flash for beginners

My delta prints just fine with the 8-bit board. It normally prints at 60-80mms, any faster and I should upgrade the board.
by Lee
Thu Oct 11, 2018 4:57 pm
Forum: General
Topic: Flash for beginners
Replies: 4
Views: 272

Re: Flash for beginners

I think most DIY-built printers are only as good as the builder. Anet's tend to have questionable electrical connectors that result in fires. Tevo's actually do pretty well when you take your time on the build. If I didn't already have my fully-modified Tarantula, I'd probably spring for a Flash. Sl...
by Lee
Thu Oct 11, 2018 4:48 pm
Forum: Introductions
Topic: New comer
Replies: 1
Views: 113

Re: New comer

Welcome!
by Lee
Tue Oct 02, 2018 6:50 pm
Forum: Hardware
Topic: Server power supply with software on and off
Replies: 14
Views: 2875

Re: Server power supply with software on and off

Does anyone fave the info from the arcaded post? It seems the site is down as of 9-28-18. Thanks in advance. The body of the arcaded post is quoted in the first post of this thread. Unfortunately, it appears the images have been lost in the ether; either the user deleted them from their DropBox acc...
by Lee
Tue Sep 25, 2018 6:27 pm
Forum: Troubleshooting
Topic: First layer print not printing evenly
Replies: 2
Views: 156

Re: First layer print not printing evenly

Though I don't have a LM, I do have another brand delta. Does your bed have level adjusters? I found those much easier than trying to handle it with software/firmware.
by Lee
Fri Sep 21, 2018 4:26 pm
Forum: General Discussion
Topic: My Tarantula does'nt use full plate to print!!!
Replies: 3
Views: 138

Re: My Tarantula does'nt use full plate to print!!!

Mechanical failure? Is the carriage running into something?

Is your slicer set to 200x280 as well? I know that S3D can override firmware size settings.
by Lee
Thu Sep 20, 2018 4:01 pm
Forum: General Discussion
Topic: My Tarantula does'nt use full plate to print!!!
Replies: 3
Views: 138

Re: My Tarantula does'nt use full plate to print!!!

What is your build plate size setting in your firmware? You may be set to 200x200.