Suggested New Sub-Forum "Tevo Tornado"

Need help with the Forum.. Suggestions etc.
Post Reply
User avatar
royg
Posts: 93
Joined: Tue Mar 28, 2017 10:56 pm
Location: Australia
Has thanked: 36 times
Been thanked: 26 times

Suggested New Sub-Forum "Tevo Tornado"

Post by royg » Thu Mar 01, 2018 10:44 pm

Lee,

Can I suggest that you add a new Sub-Forum for the Tevo Tornado printer. It's been around for a few months now, and is developing a big following.

There's also the TEVO Michelangelo, which is very new, but will probably also develop a good following.

Regards,

RoyG
Tevo Tarantula - Large Bed - E3dV6 - BLTouch
OctoPi (on a Raspberry Pi 3B)
Cura

User avatar
Lee
Site Admin
Posts: 144
Joined: Thu Mar 23, 2017 3:53 pm
Has thanked: 34 times
Been thanked: 41 times

Re: Suggested New Sub-Forum "Tevo Tornado"

Post by Lee » Fri Apr 13, 2018 6:22 pm

Yup, I'll get these setup in the next couple days.
Printer: Tarantula w/ OctoPi on Pi Zero
Firmware: MK4Duo
Slicer: Simplify3D

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest