Still no result..pse help

Troubleshoot issues with the Tarantula
Post Reply
HB9FIH
Posts: 5
Joined: Sat May 26, 2018 1:41 pm
Has thanked: 1 time

Still no result..pse help

Post by HB9FIH » Sat Oct 27, 2018 9:51 pm

I built our Tarantula in May 18. Tried to calibrate, but time was not enough, so I had to break the work.
----
Now after months later I am back and are able to continue.
----
Tarantula with TITAN Extruder - no real print result.
I know this is a calibration/setup problem. But I can not find the solution.
The extruder is not in right transport speed (direction is ok)
...........
Problem is recognized (I assume) - its the feed from Titan.
- I just received 40mm fan's for constructing a cooler.. but I am not able to print.
- also need some additional thing for the printer.

See the extruder mounted and the .... results (all defined for 100% filled):
Image
Image
You do not have the required permissions to view the files attached to this post.

HB9FIH
Posts: 5
Joined: Sat May 26, 2018 1:41 pm
Has thanked: 1 time

Re: Still no result..pse help

Post by HB9FIH » Sun Oct 28, 2018 8:05 am

Wow, now I got it.
I downloaded the Firmware easySetup2.0 from Jim Brown , and it works nearly perfect.
Also could now first time compile the firmware and upload (earlier always compile errors).

Now I am able to calibrate x/Y - is by 10mm abt 10.4mm)
You do not have the required permissions to view the files attached to this post.

Post Reply

Who is online

Users browsing this forum: Bing [Bot] and 1 guest