Bed levelling -> crash

Troubleshoot issues with the Tarantula
Post Reply
buffalo
Posts: 10
Joined: Wed Oct 25, 2017 11:21 am
Location: Austria
Has thanked: 3 times

Bed levelling -> crash

Post by buffalo » Tue Oct 31, 2017 8:29 am

Hi

I have updated my Firmware to the easy config 1.1.x.
Now, when I try to do bed levelling, the nozzle crashes the heatbed in the right end Position of the x-axis, because the green SN04 sensor is not over the bed, it is gone over the edge of the bed. What shall I do now?

regards
Friedrich

User avatar
jottkapeh
Posts: 1
Joined: Mon Jan 01, 2018 2:18 pm

Re: Bed levelling -> crash

Post by jottkapeh » Fri Nov 09, 2018 1:30 pm

Hi buffalo,

I have the same issue - good to hear it's not only me.

I've read something about the leveling process, where you should be able to define certain points (x,y coordinates) to check - but yet I have not been able to get this working.

Regards

Gesendet von meinem SM-G930F mit Tapatalk


Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest