printing issues

Troubleshoot issues with the Tarantula
Post Reply
dmanero
Posts: 1
Joined: Tue Feb 13, 2018 7:06 pm

printing issues

Post by dmanero » Thu Mar 14, 2019 2:43 pm

I have bit of a problem, I recently switched my hot end as i was having issues with it, from the stock to a v6 clone.

Now finally it hotend extrudes but, after I re leveled my bed (paper tested) and began to do a bed alignment test print. I noticed that while printing the square it would start of with under extruding then over extrude. Would do the same to all the other squares.

Any idea why this is happening, could the nozzle be faulty?
You do not have the required permissions to view the files attached to this post.

User avatar
Lee
Site Admin
Posts: 177
Joined: Thu Mar 23, 2017 3:53 pm
Has thanked: 39 times
Been thanked: 44 times

Re: printing issues

Post by Lee » Wed Mar 27, 2019 3:56 pm

I've had this issue, turned out that my slicer settings did not accurately represent my material and nozzle size.

Double check both and try again.
Printers: Tarantula | FLSun Delta
Firmware: Marlin 2.0 | Marlin 1.1.9
Slicer: Simplify3D

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests