New bed frame

Show off your Tarantula prints
User avatar
Lee
Site Admin
Posts: 173
Joined: Thu Mar 23, 2017 3:53 pm
Has thanked: 39 times
Been thanked: 44 times

Re: New bed frame

Post by Lee » Wed Jul 05, 2017 6:52 pm

I really like this design, but the warping was too much. I had to relevel the bed every print.

Make sure you print this in ABS, PETG or Raptor PLA (annealed). I had to go back to my acrylic for now, until I reprint it.
Printers: Tarantula | FLSun Delta
Firmware: Marlin 2.0 | Marlin 1.1.9
Slicer: Simplify3D

User avatar
royg
Posts: 116
Joined: Tue Mar 28, 2017 10:56 pm
Location: Australia
Has thanked: 38 times
Been thanked: 31 times

Re: New bed frame

Post by royg » Wed Jul 05, 2017 10:52 pm

Won't ABS warp even more when you're printing ?
Tevo Tornado (MKS Gen L version) - Genuine E3dV6 - BLTouch
Tevo Tarantula with a Laser Cutter/Engraver Add-on.
OctoPi (on an Odroid XU4)
Fusion 360, Cura, Slic3r, Ideamaker

User avatar
Lee
Site Admin
Posts: 173
Joined: Thu Mar 23, 2017 3:53 pm
Has thanked: 39 times
Been thanked: 44 times

Re: New bed frame

Post by Lee » Thu Jul 06, 2017 1:57 am

Higher glass transition temperature than PLA, so it shouldn't.
Printers: Tarantula | FLSun Delta
Firmware: Marlin 2.0 | Marlin 1.1.9
Slicer: Simplify3D

rebeltaz
Posts: 28
Joined: Sun Mar 26, 2017 6:28 am
Been thanked: 6 times
Contact:

Re: New bed frame

Post by rebeltaz » Sun Jul 16, 2017 1:40 am

Holy crap! Now I want to reprint all of my brackets and supports in glow in the dark! That is awesome!

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest