Configuring 3DTouch bed leveller

Tarantula hardware issues, upgrades and configurations
User avatar
Posts: 6
Joined: Tue Jun 05, 2018 7:16 pm
Has thanked: 3 times

Re: Configuring 3DTouch bed leveller

Post by BruceEsinem » Wed Jun 06, 2018 11:51 am

Good thinking, batman! Why didn't I think of asking him :-)

User avatar
Posts: 116
Joined: Tue Mar 28, 2017 10:56 pm
Location: Australia
Has thanked: 38 times
Been thanked: 31 times

Re: Configuring 3DTouch bed leveller

Post by royg » Thu Jun 07, 2018 12:54 am

Just in case it takes a while to get an answer from Jim Brown, you could try a work around as a temporary fix.

Jim Brown will be able to confirm, but I suspect that this is a Marlin Bug in this version - unless you've edited another files besides configuration.h........

So as a work-around temporary solution, try selecting a different "Bed Levelling Type" in Configuration.h.

//#define TRIPOINT
//#define LINEAR
//#define BILINEAR

Bilinear is the most recommended bed levelling type, but Linear worked OK for a long time before Bilinear came along. (Note: Tripoint is intended for Delta printers that have a circular print bed, and will probably give strange results on your printer.)


Tevo Tornado (MKS Gen L version) - Genuine E3dV6 - BLTouch
Tevo Tarantula with a Laser Cutter/Engraver Add-on.
OctoPi (on an Odroid XU4)
Fusion 360, Cura, Slic3r, Ideamaker

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest