Slanted Prints

Troubleshoot issues with the Little Monster
Post Reply
Posts: 1
Joined: Sun Feb 11, 2018 11:48 pm

Slanted Prints

Post by kizza42 » Fri Mar 09, 2018 8:32 am

Build seemed to go ok, I calibrated successfully but every print seems to print each layer offset from the one below. the prints are leaning towards the front of the printer (1st pic is the same as build orientation on the bed). Sliced in Cura and printed via Octoprint
Please help!
You do not have the required permissions to view the files attached to this post.

Posts: 1
Joined: Thu Mar 22, 2018 10:56 pm

Re: Slanted Prints

Post by Thorncastle » Fri Mar 23, 2018 12:10 am

I had an issue where I saw a print job slanting similar to that. I found the problem was because one of the XYZ motor drive pulleys (black piece attached to top motors that the belts grip onto) was slipping. The primary screw on the flat surface of the motor arm was not gripping the arm tightly enough, which put the extruder and hotend off balance due to one of the printing arms being weaker.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest