Page 1 of 1

Slicer settings for Flash

Posted: Tue Oct 16, 2018 8:44 pm
by drmacro
I'm waiting for my flash to arrive, so I figured I'd get a few things ready.

I have used Slic3r before with my A101. But I figured I give ideaMaker a shot.

Is there a list of typical/required settings somewhere?

When I started to do a new profile in ideaMaker and it wanted typical things like nozzle size, bed size, etc.

But I got to things like max bed/nozzle temp, steps, etc. there is little info to found on the web.

Any pointers appreciated! :)

Re: Slicer settings for Flash

Posted: Fri Oct 26, 2018 3:30 am
by jimbuckeye
I have a Tornado Gold and am trying to set up a profile as well. If you are successful, please post details.

Re: Slicer settings for Flash

Posted: Fri Oct 26, 2018 1:30 pm
by drmacro
Yeah, not much to be found...

It's similar to others in the same class, so similar settings might be a good place to start.

I'll give it try when it arrives.