Suggested New Sub-Forum "Tevo Tornado"

Need help with the Forum.. Suggestions etc.
Post Reply
User avatar
royg
Posts: 112
Joined: Tue Mar 28, 2017 10:56 pm
Location: Australia
Has thanked: 38 times
Been thanked: 31 times

Suggested New Sub-Forum "Tevo Tornado"

Post by royg » Thu Mar 01, 2018 10:44 pm

Lee,

Can I suggest that you add a new Sub-Forum for the Tevo Tornado printer. It's been around for a few months now, and is developing a big following.

There's also the TEVO Michelangelo, which is very new, but will probably also develop a good following.

Regards,

RoyG
Tevo Tornado (MKS Gen L version) - Genuine E3dV6 - BLTouch
Tevo Tarantula with a Laser Cutter/Engraver Add-on.
OctoPi (on an Odroid XU4)
Fusion 360, Cura, Slic3r, Ideamaker

User avatar
Lee
Site Admin
Posts: 151
Joined: Thu Mar 23, 2017 3:53 pm
Has thanked: 36 times
Been thanked: 42 times

Re: Suggested New Sub-Forum "Tevo Tornado"

Post by Lee » Fri Apr 13, 2018 6:22 pm

Yup, I'll get these setup in the next couple days.
Printer: Tarantula w/ OctoPi on Pi Zero
Firmware: MK4Duo
Slicer: Simplify3D

User avatar
royg
Posts: 112
Joined: Tue Mar 28, 2017 10:56 pm
Location: Australia
Has thanked: 38 times
Been thanked: 31 times

Re: Suggested New Sub-Forum "Tevo Tornado"

Post by royg » Tue Jun 12, 2018 12:51 am

Lee,

Looks like we need to add some more to your workload ........

Probably need to add another new Tevo printer to the Forum.

Tevo Flash

Image

https://www.aliexpress.com/store/produc ... 2a72xiDS5o

The Flash is available either 90% built (like the Tornado), or as a Kit. As a kit build, the Tevo Flash is likely to generate a larger DIY base than the Tornado and the other Tevo 90% and 100% built printers have, and so could generate more traffic here. There's also some discussion (possibly scuttlebutt ?) around the web that the Tevo Flash Kit version will replace the Tarantula when Tarantula stocks run out.

Over to you......

Regards,

RoyG
Tevo Tornado (MKS Gen L version) - Genuine E3dV6 - BLTouch
Tevo Tarantula with a Laser Cutter/Engraver Add-on.
OctoPi (on an Odroid XU4)
Fusion 360, Cura, Slic3r, Ideamaker

User avatar
Lee
Site Admin
Posts: 151
Joined: Thu Mar 23, 2017 3:53 pm
Has thanked: 36 times
Been thanked: 42 times

Re: Suggested New Sub-Forum "Tevo Tornado"

Post by Lee » Wed Jul 18, 2018 4:47 pm

I'm working on this today, getting these subforums going.
Printer: Tarantula w/ OctoPi on Pi Zero
Firmware: MK4Duo
Slicer: Simplify3D

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests