Michelango Z-axis home lower than bed goes
-
- Posts: 6
- Joined: Sun Jul 29, 2018 7:22 am
Michelango Z-axis home lower than bed goes
I have my bed as low as it can go, the springs are fully compressed and the z-axis has to still be set to +1.6 for me to be able to level it. Anyone else have this problem out of the box? Can I set it so home is above this besides setting an offset? Would it be better to loosen the bed and set the offset higher?
-
- Posts: 6
- Joined: Sun Jul 29, 2018 7:22 am
Re: Michelango Z-axis home lower than bed goes
Z-endstop. Yeah, that was the simple answer. Thanks, I'm still figuring this all out.
Who is online
Users browsing this forum: No registered users and 0 guests